What Is Fat Lime?
Fat lime is also known as Rich lime, High calcium lime, Pure lime, White lime. It is obtained by calculating limestones.
When water is added to this lime, it produces hissing sound, a lot of heat is liberated it cracks and its volume is increased by 2-3 times the presence of air is essential for its setting. Hence it does not set.
• Under water.
• Below Ground.
• In interior joints of a thick wall.
It is used for white-washing, plastering and filling thin joints.
Fat lime is highly plastic and is soluble in water.
To improve its hydraulic property, fat lime is mixed with surkhi (Brick powder) such mortar can set even in the absence of air and hence can be used for joints of thick, walls, or works below ground.
Also, read: Difference Between Bitumen and Tar | What Is Bitumen | What Is Tar
What Is Hydraulic Lime?
This lime does not require Co2 from the atmosphere for the setting. Hence it can set under-water. It is used in construction works. Strength is required.
This lime is not suitable for plaster-work because any unslacked particle may slake after some days causting blistering in plaster.
To improve this property this lime is ground to powder and then mixed with sand the mortar thus prepared is kept in a heap for about a week, and it is ground again. Such mortar prepared from hydraulic lime suitable for plaster-work.
Depending upon the percentage of clay content, hydraulic lime is divided into the following types,
Type of Hydraulic Lime.
1. Eminently hydraulic lime
2. Moderately hydraulic lime
3. Feebly hydraulic lime
Eminently hydraulic lime:
Clay content – 21 to 30%
Slaking – Slow with difficulty
Setting – About 24 hours
Hyraulicity – Eminent
Uses – Can be used in important masonry works in place of cement
Moderately hydraulic lime:
Clay content – 11 to 20%
Slaking – After 1.5 hours
Setting – About one week
Hyraulicity – Moderate
Uses – Masonry works
Feebly hydraulic lime
Clay content – 05 to 10%
Slaking – After few minutes
Setting – Sets in water after about 3 weeks
Hyraulicity – Feeble
Uses – Ordinary masonry works.
Also, read: What Is Classification of Bricks | Classification of Bricks Different Base
Difference Between Fat Lime and Hydraulic Lime
| Detail | Fat Lime | Hydraulic Lime |
|---|---|---|
| Composition | More Percentage of CaO clay content less then 5% | Ca + clay content from 5 to 30 % and some % of iron oxide |
| Slaking | Slakes vigorously with hissing sound and cracking volume increased by 2 to 3 times slaking continues upto 3-4 hours. | Not much heat is liberated. No hissing sound or cracking volume increases by 1.2 times slaking continues up to 1-2 days |
| Setting | Sets slowly in presents of air. Absorbs CO2 from atmosphere and from CACO3. It does not have hydraulicity and hence can not set under water. | Sets under water – CaO content sets like fat lime calcium silicate & crystalline structures are formed they set like cement. It possesses hydraulidty. |
| Strength | It is not strong and hence can not be used where strength is requierd. | It is strong and can be used like cement |
| Use | Plastering, white washing preparing and mortar with surkhi mix. | Suitable for thick walls, works below ground in damp condition |
Like this post? Share it with your friends!
Suggested Read –
Leave a Reply